NEW
 
Allow to send four values on same message
Download firmware (V1.2)
Download configuration software tool
Take advantage doing your racing car instrumentation.
Can be used with : Display DC4D
Download 4IN Full datasheet (pdf)
The 4IN Full is a module to transmit on a CAN bus measurements in mV and frequencies of 4 analog inputs. Each input has a 5V, Vbat, signal and analog ground to avoid splices on sensor side wiring.
A 1k21 pull up resistor is automatic or manual switchable for also allow temperature measurements (NTC or PT1000) without adding components.
A free appplication windows is available to configure:
- CAN speed
- Frequency of messages (one message for each entry)
- ID Message
- Pullup status
 

Characteristics:
- Size:47x31x10mm without cable
- Weight: 47g
- Cables: about 10cm cable for each input and CAN (KU AWG22 with DR25 sleeve)
- Envelope:Aluminium
- Protection: IP67 (tropicalized PCB)
- Temp: - 20ºC / +80ºC
- ADC: 12bits, from 0 to 5000mV
- Frequencies: 1Hz to 65kHz
- Message recurrence: 1ms to 1s
- Configuration: via PC (Windows) and USB / CAN LAWICEL
 
Sold without connector
USB/CAN tool sold as option
HOME
PRODUCTS
DOWNLOAD
CONTACT
NEW - NOUVEAU - NUEVO - NUOVO - NEUE