Take advantage doing your racing car instrumentation.
NEW Gen 2 version
Can be used with : Display DC4D
Download 4IN Light datasheet (not available yet)
The 4IN Light is a module to transmit on a CAN bus measurements in mV of 4 analog inputs. Each input has a 5V, signal and analog ground to avoid splices on sensor side wiring.
A 1k21 pull up resistor is automatic or manual switchable for also allow temperature measurements (NTC or PT1000) without adding components.
Also, 1k21 pull down can be internally connected for set input at Vcc/2 and use it as dual digital input.
A free appplication windows is available to configure:
- CAN speed (auto baudrate functionnality)
- Frequency of messages (one message entry)
- ID Message
- CAN message data fully user configurable
- CAN message forwarding on smae bus
- Pull Up
- Pull Down (new)
- mV to physical value elaborations (new)
- Frequencies measurement up to 5kHz with TTL signal (new)
- Virtual rotary (using Up/Down analog as digital inputs) (new)
Characteristics:
- Size:44x18x10mm without cable
- Weight: 30g
- Cables: arround 18cm cable for each input and CAN (KU AWG24 with DR25 sleeve)
- Enclosure:Aluminium
- Protection: IP67 (filled with PU resin)
- Temp: - 20ºC / +80ºC
- ADC: 12bits, from 0 to 5000mV
- Message recurrence: 1ms to 1s
- Configuration: via PC (Windows) and USB/CAN LAWICEL or PEAK system
Sold without connector
NEW - NOUVEAU - NUEVO - NUOVO - NEUE
